Frame Straightening - Frame Racks Make It Easy

Why Vector Pulling?
For years the Europeans and the Japanese have preferred Vector pulling frame racks over tower type frame rack machines because of its versatility, multiple pulls and ease of operation.  The problem was most were either bench or floor systems.  Now, Black Jack gives you all this power and capability with the convenience of a Drive-On rack!  No more working on the floor!  Now you can anchor, multiple pull and measure with ease... Now the cards are stacked in your favor!

Get what you've always wanted from a frame straightener:

• Tilt down/Drive-On ... Fast!
• Low drive-up angle - No wheel spin!
• Perfect working height - ideal for body work!
• Winch and dead wheel dolly provided for dead cars.
• Mobile tool board - less walking ... more production!
• Complete - more chains, clamps, full frame anchoring, down pull wheel, pull cable and much more!

*Load car into Sill Clamps in ... "5 Minutes"

Center scissors lift to put car into sill clamps ... almost too easily!

• Lift can easily be positioned anywhere along center alley of machine with pull handle.
• Lift one end at a time, sill clamp heads pivot to accomodate angle.
• Slide out of way after mounting for total access to bottom of car
• Also great for wheel alignment equipment!
• Easy to use, worker friendly

Unlimited access to car ...

• Access to creeper under car to measure, hammer, weld, etc.
• Access to top of car is just as easy ... only a 23" step up!
• Access to front, back and sides for pulling 360°

Make any pull you want ... even back on hinge pillar while door is on car - No old-fashioned pull tower can do this!  Just bolt socket base and anchor block anywhere on machine for pulls never before possible!