Special Problems... We Solve Them

Posted Sat, 04/10/2010 - 10:19 by tsliker

Got a wheel pushed back?

Got a big kink just behind the crossmember?

You need at least 3 Pulls... (We don't even sell a 2 Pull machine) 33 tons where you need it. One pull forward on the rail end... One pull forward on the lower A frame... One pull around the rail at the point of the kink pulling out to the side.



Need to Pull Up? Just add extensions	Need to Pull Down? Bolt the Down Pull Wheel anywhere on the machine	Need to Push and Pull? Push a rail pooch back in while you pull to the side
Side Pulls ... No Problem! Pull out, Pull up, Pull back - High pulls are made with extention tubes. Notice pull to the rear on rocker sill... Pull anywhere you want! One air line runs all your pulls via air manifold.

*Patented Side Pullers can easily be positioned anywhere along the side of the machine. Loosen one bolt and position in the desired location. Tighten the bolt and you are ready to pull.	*Patented Forward Pullers can easily be positioned anywhere across the front of the machine or across the ends after the ramps have been set aside... for true 360° pulling, a must!	Up to 3 pulls from any pull station. Socket bases engage holes in top of pull station with dowels on bottom - reposition as needed for versatile pull angle. Forward pullers self engage to machine under load - No Bolts!